Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the battery on the underside of the laptop.
-
Push the two battery clips following the direction of the arrows.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull battery away from computer until it is fully removed.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 10 2.5x5 mm screws from the base of the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unscrew the final 2.5x5 mm screw attached to the cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unscrew the 2.5x5 mm screw inside the RAM compartment.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the disk drive from the side of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unscrew the two 2x3 mm screws inside the disk drive compartment.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the computer over, and open the laptop.
-
Use a plastic opening tool to begin to remove the keyboard.
-
Use your hands to finish separating the keyboard from the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the black clip from the tan connection for the keyboard.
-
Pull the the connection away from the clip.
-
Move the keyboard away from the laptop.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the black clips from the tan connections for all 3 locations marked.
-
Remove the connections from the clips.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use plastic opening tools to remove base cover.
-
Use your hands to fully remove cover from the base.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the two cables that connect the speaker and the fan.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the ribbon cable over the screw to reveal it. Flip up the latch and pull gently on the ribbon to remove it from the connector.
-
Unscrew the 2.5x5 mm screw from the fan.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unscrew the six 2.5x5mm screws from the motherboard.
-
Note that this screw may be "retained" by the loop at the end of the grounding wire.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the black and yellow cable from the motherboard.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.
2 comentarios
After pulling off the battery, the step to remove the four M2x3 mm screws was forgotten. Please update the guide.