Dell Inspiron N4110 Motherboard Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

Is your motherboard damaged or are you looking for an upgrade? if so, this guide will show you how to locate and replace a motherboard.

Qué necesitas

Paso 1 Battery

Dell Inspiron N4110 Motherboard Replacement, Battery: paso 1, imagen 1 de 1

Make sure the laptop is off and unplugged before starting this step.
Locate the battery on the underside of the laptop.
Push the two battery clips following the direction of the arrows.

Traducir

Paso 2

Push upward from the base of the battery.

Traducir

Paso 3

Pull battery away from computer until it is fully removed.

Traducir

Paso 4 Fan

Dell Inspiron N4110 Motherboard Replacement, Fan: paso 4, imagen 1 de 2

Dell Inspiron N4110 Motherboard Replacement, Fan: paso 4, imagen 2 de 2

Remove the 10 2.5x5 mm screws from the base of the laptop.

Traducir

Paso 5

Unscrew the final 2.5x5 mm screw attached to the cover.
This screw is "captive" and does not detach from the cover. Make sure the screw is fully unscrewed before attempting to remove the cover.

Traducir

Paso 6

Remove the cover from the laptop.

Traducir

Paso 7

Unscrew the 2.5x5 mm screw inside the RAM compartment.

Traducir

Paso 8

Remove the disk drive from the side of the computer.
There is no need to press the button, the drive will come out.

Traducir

Paso 9

Unscrew the two 2x3 mm screws inside the disk drive compartment.

Traducir

Paso 10

Dell Inspiron N4110 Motherboard Replacement: paso 10, imagen 3 de 3

Flip the computer over, and open the laptop.
Use a plastic opening tool to begin to remove the keyboard.
Use your hands to finish separating the keyboard from the laptop.
This can be a bit challenging, but it will come loose.

Traducir

Paso 11

Lift the black clip from the tan connection for the keyboard.
Pull the the connection away from the clip.
Move the keyboard away from the laptop.
With the keyboard removed, consider this opportunity to more freely clean it out with some compressed air.

Traducir

Paso 12

Lift the black clips from the tan connections for all 3 locations marked.
Remove the connections from the clips.

Traducir

Paso 13

Unscrew the five 2.5x5 mm screws.

Traducir

Paso 14

Use plastic opening tools to remove base cover.
Use your hands to fully remove cover from the base.
This may be difficult, but it is possible.

Traducir

Paso 15

Disconnect the two cables that connect the speaker and the fan.
These can just be pulled out, they do not have clips.

Traducir

Paso 16

Disconnect the ribbon cable over the screw to reveal it. Flip up the latch and pull gently on the ribbon to remove it from the connector.
Unscrew the 2.5x5 mm screw from the fan.

Traducir