Dell Inspiron 600m LCD Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

You will need a Philips screwdriver, an anti-static wrist strap, and a wedge type tool such as a flat-head screwdriver. This guide will walk you through how to replace the LCD screen on your Dell Inspiron 600m.

Qué necesitas

Paso 1 Battery

Dell Inspiron 600m LCD Replacement, Battery: paso 1, imagen 1 de 3

Dell Inspiron 600m LCD Replacement, Battery: paso 1, imagen 2 de 3

Dell Inspiron 600m LCD Replacement, Battery: paso 1, imagen 3 de 3

Flip laptop upside down and locate the battery as shown in the images.
Push in the tab on the battery and lift up. The battery should detach very easily.

Traducir

Paso 2 LCD

Dell Inspiron 600m LCD Replacement, LCD: paso 2, imagen 1 de 2

Dell Inspiron 600m LCD Replacement, LCD: paso 2, imagen 2 de 2

Locate the rubber dots on the plastic around the lcd panel.
Use your fingernails or a flat-head screwdriver to remove the rubber dots around the screen by pushing any direction on them.
Underneath the rubber dots will be screws. Remove them with the #00 screwdriver.

Traducir

Paso 3

After removing the screws under the rubber dots, use your plastic opening tool to un-clip the plastic around the screen.
There are clips about every inch around the right, left, and top of the plastic. Be sure that all of them are unclipped.

Traducir

Paso 4

Lift the plastic around the screen off after it is un-clipped by pulling straight up on it.
The bottom part of the plastic is a little sticky.

Traducir

Paso 5

Underneath the plastic around the edge, there are 2 screws on each side. Remove them with a Philips #00 screwdriver.
The middle screw does not need to be removed.

Traducir

Paso 6

After all the screws around the edge have been removed, lift the LCD panel off of the base.
The LCD is still attached to the computer. Do not pull too hard or you could break the cable.

Traducir

Paso 7

Dell Inspiron 600m LCD Replacement: paso 7, imagen 3 de 3

Flip the LCD panel over.
Do not touch on or near the back of the panel where is says "Don't Touch". LCD panels contain mercury which is hazardous to humans.
Remove the cable by squeezing each side of the connector and gently pulling straight out.