Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Localiza el interruptor de liberación de la batería en la parte inferior del portátil.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 4.00 mm Phillips #1 screws from the battery tray.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Insert the flat end of a spudger into the slot on the right side of the central control cover and pry it up.
-
Carefully pull the central control cover up along its edges.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Peel back the silver tape securing the ribbon cable to the cover.
-
Pull the small brown latch on the ribbon cable connector out.
-
Disconnect the ribbon cable to completely free the central control cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 5.75 mm Phillips #1 screws securing the keyboard to the laptop.
-
Gently slide the keyboard towards the display until the tabs on its front side are free.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to gently lift the ribbon cable retaining flap.
-
Disconnect the ribbon cable.
-
Shift the keyboard sideways enough to free one side from it's retaining tab. Then lift the keyboard away from the laptop.
-
Cancelar: No complete esta guía.
11 personas más completaron esta guía.
3 comentarios
why did you say to remove the central control cover? It is so hard top get it back! Especially when the guide on laptopkeyboard.com seems to suggest that this is unnecessary.
Thank you so much…!
thanks, marvelous site . I am in