Introducción

This guide shows how to remove the LCD assembly from a Dell Inspiron 15-7547

Partes

No se requieren partes.

  1. Close the display and flip the laptop on its back.
    • Close the display and flip the laptop on its back.

    • Loosen the ten 5.0 mm-long Phillips #0 screws.

      • The four screws marked with orange will remain captive to the cover.

  2. Pry the cover open with a plastic spudger   and remove it.
    • Pry the cover open with a plastic spudger and remove it.

    • Remove the 3.0 mm-long Philips #0 screw at the end of the Wifi-Card

    • Remove the Wifi-Card from its socket by pulling away and up from the connector.

    • Disconnect the white and black cables from the Wifi-Card.

      • Make a note of which wire goes where for reconnecting them to the replacement card.

    • Remove the six 7.0 mm-long Philips #0 screws that mount the hinges.

    • Use a spudger to unlatch and unplug the display cable.

      • There will be a notch on the side of the connector.

    • Raise the left and right hinges.

    • Remove the LCD display assembly from the laptop.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Kevin Smith

Miembro Desde 10/09/18

303 Reputación

2 Guías creadas

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 4

Últimos 30 Días: 39

Todo El Tiempo: 80