Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using tweezers, remove the circular stickers that are covering the two screws near the middle of the back cover. Stick them to the laptop next to the screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a Phillips #0 screwdriver, loosen all seven 2.5mm screws on the back cover of the device.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opening tool, begin to separate the back cover from the body of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your hands, pull the back cover fully off of the body of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the ribbon cable from the motherboard. To do this, lift up the black tab hinge securing the ribbon cable and pull the cable up and then out of the port.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Release the keyboard from the body. To do this, push on the two keyboard release holes with something thin and cylindrical like a spudger or a pencil.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the keyboard from the body. To do this, use a plastic prying tool to get under the keyboard and pry it up from the computer body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once you have separated the keyboard and the body using a spudger or plastic opening tool, use your hands to pull it away from and off of the computer.
-
Cancelar: No complete esta guía.
13 personas más completaron esta guía.