Saltar al contenido principal

Dell Axim X30 Screen Replacement

Qué necesitas

  1. Dell Axim X30 Screen Replacement, Screen: paso 1, imagen 1 de 3 Dell Axim X30 Screen Replacement, Screen: paso 1, imagen 2 de 3 Dell Axim X30 Screen Replacement, Screen: paso 1, imagen 3 de 3
    • Remove the four rubber feet with your fingers.

  2. Dell Axim X30 Screen Replacement: paso 2, imagen 1 de 2 Dell Axim X30 Screen Replacement: paso 2, imagen 2 de 2
    • Trigger battery release by inserting a nylon spudger into the battery release tab.

    • Slide tab and pull upwards on the battery to remove. Use the finger slots near the battery.

  3. Dell Axim X30 Screen Replacement: paso 3, imagen 1 de 1
    • Remove the four 12.7mm screws under rubber feet with a JIS #0 screwdriver.

  4. Dell Axim X30 Screen Replacement: paso 4, imagen 1 de 1
    • Remove back panel with a plastic opening tool. Follow the edge of the device around the entire perimeter.

    • The back panel should just pop off.

  5. Dell Axim X30 Screen Replacement: paso 5, imagen 1 de 3 Dell Axim X30 Screen Replacement: paso 5, imagen 2 de 3 Dell Axim X30 Screen Replacement: paso 5, imagen 3 de 3
    • Disconnect ribbon cables.

    • You may need to use a little force to disconnect them.

    • Disconnect red and white wired connector for speaker and motherboard battery.

  6. Dell Axim X30 Screen Replacement: paso 6, imagen 1 de 2 Dell Axim X30 Screen Replacement: paso 6, imagen 2 de 2
    • Remove three 12.7mm JIS #0 screws.

  7. Dell Axim X30 Screen Replacement: paso 7, imagen 1 de 1
    • Carefully remove motherboard.

  8. Dell Axim X30 Screen Replacement: paso 8, imagen 1 de 2 Dell Axim X30 Screen Replacement: paso 8, imagen 2 de 2
    • Remove the two 9.6 mm screws by the speaker and green battery with a JIS #0 screwdriver.

  9. Dell Axim X30 Screen Replacement: paso 9, imagen 1 de 2 Dell Axim X30 Screen Replacement: paso 9, imagen 2 de 2
    • Remove black plastic board.

  10. Dell Axim X30 Screen Replacement: paso 10, imagen 1 de 2 Dell Axim X30 Screen Replacement: paso 10, imagen 2 de 2
    • Gently apply pressure on the right plastic frame by plastic clip marked on the picture.

    • Apply pressure to the bottom of the screen and press it towards you.

    • Remove screen from plastic case.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Peter Reilly

Miembro Desde 03/28/18

196 Reputación

1 Guía escrita

Equipo

IUPUI, Team S2-G5, Harley Spring 2018 Miembro de IUPUI, Team S2-G5, Harley Spring 2018

IUPUI-HARLEY-S18S2G5

3 Miembros

2 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 6

Ultimos 30 días: 10

Todo El Tiempo: 761