Saltar al contenido principal

De Longhi Heater temperature Sensor

  1. De Longhi Heater temperature Sensor, Temperature Sensor: paso 1, imagen 1 de 1
    • Heater unit bricked with PF error (fault temperature sensor)

  2. De Longhi Heater temperature Sensor: paso 2, imagen 1 de 1
    • Remove the four Phillips screws with a Phillips screwdriver

    • Remove the remaining 2 screws with a Torx screwdriver

    • Remove the cover

  3. De Longhi Heater temperature Sensor: paso 3, imagen 1 de 1
    • Open the clamps by unhooking them with pliers or using a flathead screwdriver.

  4. De Longhi Heater temperature Sensor: paso 4, imagen 1 de 1
    • Unscrew the Phillips screw to remove the temperature sensor.

  5. De Longhi Heater temperature Sensor: paso 5, imagen 1 de 1
    • Unclip the temperature sensor connector from the motherboard.

  6. De Longhi Heater temperature Sensor: paso 6, imagen 1 de 1
    • The temperature sensor had broken because it was corroded by moisture.

  7. De Longhi Heater temperature Sensor: paso 7, imagen 1 de 2 De Longhi Heater temperature Sensor: paso 7, imagen 2 de 2
    • With a soldering iron I proceeded to weld the broken part and to connect the 2 tracks by applying electric wire and some tin.

    • If the component can not be repaired, you can find the complete electronic board replacement on eBay

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Un agradecimiento especial a estos traductores:

it en

100%

Estos traductores nos están ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›

Smilzo

Miembro Desde 11/09/13

11,267 Reputación

39 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 14

Ultimos 30 días: 57

Todo El Tiempo: 4,382