Saltar al contenido principal
  1. Remove the four screws with a Torx T8 screwdriver to access the back con board.
    • Remove the four screws with a Torx T8 screwdriver to access the back con board.

  2. Remove the three Phillips screws using a Phillips #00 screwdriver.
    • Remove the three Phillips screws using a Phillips #00 screwdriver.

  3. With tweezers, gently remove the large con board tab. Use your hands to remove the two small clips. Pull out from the socket, in a horizontal direction.
    • With tweezers, gently remove the large con board tab.

    • Use your hands to remove the two small clips. Pull out from the socket, in a horizontal direction.

  4. Kits de Reparación de Android

    Estás a un kit de tu nueva pantalla o batería.

    Comprar Ahora

    Kits de Reparación de Android

    Estás a un kit de tu nueva pantalla o batería.

    Comprar Ahora
  5. Peel off the rubber grips to access the screw holes. Make sure to save your grips and do not to get them stuck to anything, you are going to want to save the adhesive.
    • Peel off the rubber grips to access the screw holes.

    • Make sure to save your grips and do not to get them stuck to anything, you are going to want to save the adhesive.

    • Remove the back board and set it aside.

  6. Pull apart the back plastic panel. Recommended tool for this would be the metal spudger, but not required.
    • Pull apart the back plastic panel.

    • Recommended tool for this would be the metal spudger, but not required.

    • Once the back panel is off, you will have access to the motherboard.

  7. Disconnect ribbon tabs 1,2,5,8G, and 3. Remove ribbon tab by pulling gently along motherboard. Do not pull straight out. Then remove the plugs
    • Disconnect ribbon tabs 1,2,5,8G, and 3.

    • Remove ribbon tab by pulling gently along motherboard. Do not pull straight out.

    • Then remove the plugs

  8. With the Phillips #00 screwdriver, remove the two Phillips screws. With the Phillips #00 screwdriver, remove the two Phillips screws.
    • With the Phillips #00 screwdriver, remove the two Phillips screws.

  9. Double check to make sure all tabs, plugs and screws are removed or disconnected.
    • Double check to make sure all tabs, plugs and screws are removed or disconnected.

    • Gently lift motherboard out of the case.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Do you know here can i buy a main board for phantom 4 advanced remote controller?

carl_darklife - Contestar

I would like to know too, can’t find one anywhere

Luke James -

Añadir comentario

Ver Estadísticas:

Past 24 Hours: 1

Past 7 Days: 6

Past 30 Days: 25

Global: 317