Repara tus cosas Comunidad Tienda

CyberPower UPS Battery Replacement

Introducción

This guide will instruct you on replacing the battery on the Cyberpower Model# 1000PFCLCD UPS battery backup unit.

Qué necesitas

  1. CyberPower UPS Battery Replacement, Battery: paso 1, imagen 1 de 2 CyberPower UPS Battery Replacement, Battery: paso 1, imagen 2 de 2

    • Power down the unit by pressing the power button until the display goes black.

    • This is usually about 3 seconds.

    • Unplug the power cord from the wall outlet.

    Editar

  2. CyberPower UPS Battery Replacement: paso 2, imagen 1 de 3 CyberPower UPS Battery Replacement: paso 2, imagen 2 de 3 CyberPower UPS Battery Replacement: paso 2, imagen 3 de 3

    • Remove the battery plate cover at the bottom of the UPS using a Phillips #1 screwdriver.

    • If the screwdriver is not magnetized, tap on the cover plate to completely remove the screw.

    Editar

  3. CyberPower UPS Battery Replacement: paso 3, imagen 1 de 2 CyberPower UPS Battery Replacement: paso 3, imagen 2 de 2

    • Slide the battery cover plate to the left.

    • Grasp the battery plate cover and lift it off the the UPS.

    Editar

  5. CyberPower UPS Battery Replacement: paso 4, imagen 1 de 3 CyberPower UPS Battery Replacement: paso 4, imagen 2 de 3 CyberPower UPS Battery Replacement: paso 4, imagen 3 de 3

    • Pull out the battery to expose the terminal connectors.

    • Use needlenose pliers to disconnect both battery terminal connectors.

    • Do not pull the connectors by the wires, pull connectors by grabbing the connector itself.

    • With the battery terminal connectors disconnected, slide the battery all the way out.

    Editar

  6. CyberPower UPS Battery Replacement: paso 5, imagen 1 de 3 CyberPower UPS Battery Replacement: paso 5, imagen 2 de 3 CyberPower UPS Battery Replacement: paso 5, imagen 3 de 3

    • The replacement battery should be a 12 volt, 9 amp-hour, sealed lead acid battery with f2 type connectors.

    • Install the new battery and reconnect the terminals.

    Editar

  7. CyberPower UPS Battery Replacement: paso 6, imagen 1 de 3 CyberPower UPS Battery Replacement: paso 6, imagen 2 de 3 CyberPower UPS Battery Replacement: paso 6, imagen 3 de 3

    • Slide the battery cover plate to the left.

    • Insert the screw to secure the battery cover plate.

    • Tighten the screw with a Phillips #1 screwdriver.

    Editar

  8. CyberPower UPS Battery Replacement: paso 7, imagen 1 de 3 CyberPower UPS Battery Replacement: paso 7, imagen 2 de 3 CyberPower UPS Battery Replacement: paso 7, imagen 3 de 3

    • Plug system into the wall outlet.

    • Press the power button to turn on the unit.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 16

Ultimos 7 días: 72

Ultimos 30 días: 301

Todo El Tiempo: 12,533