Saltar al contenido principal

Partes

No se especificaron partes.

  1. Unplug your food processor before starting any disassembly. Remove the small pusher by rotating it clockwise and lifting up. Remove the small pusher by rotating it clockwise and lifting up.
    • Unplug your food processor before starting any disassembly.

    • Remove the small pusher by rotating it clockwise and lifting up.

  2. Remove the large pusher by grabbing its sides and pulling up.
    • Remove the large pusher by grabbing its sides and pulling up.

    • There may be a clicking sound from the safety feature being disengaged in this step.

  3. Remove the lid from the bowl by turning it clockwise and lifting. Remove the lid from the bowl by turning it clockwise and lifting. Remove the lid from the bowl by turning it clockwise and lifting.
    • Remove the lid from the bowl by turning it clockwise and lifting.

  4. Take out the blades by grabbing the plastic center piece and lifting up.
    • Take out the blades by grabbing the plastic center piece and lifting up.

    • Avoid contact with blades as they are extremely sharp.

  5. Position the handle of the bowl so that it is on your left. Grab the handle and push clockwise. Lift up the bowl to remove it. Grab the handle and push clockwise. Lift up the bowl to remove it.
    • Position the handle of the bowl so that it is on your left.

    • Grab the handle and push clockwise. Lift up the bowl to remove it.

  6. Turn the food processor's base upside down by lifting it up and turning it over. Position the base so that the on and pulse buttons are facing you.
    • Turn the food processor's base upside down by lifting it up and turning it over.

    • Position the base so that the on and pulse buttons are facing you.

    • Place the base on top of the food processor's bowl to keep the base from wobbling while you work on it.

  7. Remove the two 13.0mm screws that hold down the casing with a Phillips #2 screwdriver. Remove the two 13.0mm screws that hold down the casing with a Phillips #2 screwdriver.
    • Remove the two 13.0mm screws that hold down the casing with a Phillips #2 screwdriver.

  8. Lift up the front left and the back right rubber feet by pulling back the rubber with your fingers. Remove the 13.0mm screw under each rubber foot with a Phillips #2 screwdriver. Remove the 13.0mm screw under each rubber foot with a Phillips #2 screwdriver.
    • Lift up the front left and the back right rubber feet by pulling back the rubber with your fingers.

    • Remove the 13.0mm screw under each rubber foot with a Phillips #2 screwdriver.

  9. Lift off the back casing by raising it upward. Lift off the back casing by raising it upward.
    • Lift off the back casing by raising it upward.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Sonya Dick

Miembro Desde 05/10/16

352 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 10-3, Livingston Fall 2016 Miembro de Cal Poly, Team 10-3, Livingston Fall 2016

CPSU-LIVINGSTON-F16S10G3

3 Miembros

7 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 54