Saltar al contenido principal

Introducción

This guide will help you with replacing the power cord if your device is not receiving power.

The replacement will require a soldering iron.

  1. Unplug the maker, remove the coffee pot, and flip upside down. Unplug the maker, remove the coffee pot, and flip upside down.
    • Unplug the maker, remove the coffee pot, and flip upside down.

  2. Remove the five 1.6mm Phillips #1 screws from the bottom panel. Remove the bottom panel.
    • Remove the five 1.6mm Phillips #1 screws from the bottom panel.

    • Remove the bottom panel.

  3. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  4. Push the power cord inward and away from the plastic protection plate. Push the power cord inward and away from the plastic protection plate.
    • Push the power cord inward and away from the plastic protection plate.

  5. Remove the two 1.4mm Phillips #0 screws from the plastic protection plate. Remove the plastic protection plate.
    • Remove the two 1.4mm Phillips #0 screws from the plastic protection plate.

    • Remove the plastic protection plate.

  6. Remove the two 1.6mm Phillips #1 screws from the heating element. Using a flathead screwdriver to remove the outer clips holding the heating unit in place. Flip the heating element up to allow access to the circuit board.
    • Remove the two 1.6mm Phillips #1 screws from the heating element.

    • Using a flathead screwdriver to remove the outer clips holding the heating unit in place.

    • Flip the heating element up to allow access to the circuit board.

  7. Pull out the circuit board and rest it on the side of the machine. Desolder the power cable from the motherboard.
    • Pull out the circuit board and rest it on the side of the machine.

    • Desolder the power cable from the motherboard.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Nicholas Eales

Miembro Desde 25/01/18

233 Reputación

1 Guía escrita

Equipo

USF Tampa, Team S20-G4, Passmore Spring 2018 Miembro de USF Tampa, Team S20-G4, Passmore Spring 2018

USFT-PASSMORE-S18S20G4

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 3

Últimos 30 Días: 13

Todo El Tiempo: 139