Saltar al contenido principal

Craftsman Model 315.10721 Table Guard Replacement

Qué necesitas

  1. Craftsman Model 315.10721 Table Guard Replacement, Table Guard: paso 1, imagen 1 de 1
    • Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.

  2. Craftsman Model 315.10721 Table Guard Replacement: paso 2, imagen 1 de 1
    • Pivot the table guard from its upright position to an angle.

    • Using a Phillips #1 screwdriver, remove the 1" Phillips screw and the nut on the opposite side.

  3. Craftsman Model 315.10721 Table Guard Replacement: paso 3, imagen 1 de 1
    • Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.

    • Carefully remove the main case to expose the inside of the saw.

  4. Craftsman Model 315.10721 Table Guard Replacement: paso 4, imagen 1 de 1
    • Remove the old table guard by gently lifting it away from the main case.

    • Replace the old table guard with the new one by placing it in the same orientation as the one removed.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Riley Hilliker

Miembro Desde 10/14/14

557 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 4-47, Amido Fall 2014 Miembro de Cal Poly, Team 4-47, Amido Fall 2014

CPSU-AMIDO-F14S4G47

4 Miembros

5 Guías creadas

2 comentarios

Where can I get a replacement table guard???

Roger Coyle - Contestar

Where can I get a replacement table guard for this jig saw????????

Roger Coyle - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 7

Todo El Tiempo: 593