Saltar al contenido principal

Core Assembly Removal

Qué necesitas

  1. Core Assembly Removal, Unfasten the back cover screws: paso 1, imagen 1 de 1
    • Before starting repairs, take your watch off the charger and power it down.

    • Use a Tri-point Y00 driver to unfasten the four screws on the back of the watch.

    • Don’t worry about removing the screws, they will stay in place in the back cover.

  2. Core Assembly Removal, Wedge open the back cover: paso 2, imagen 1 de 2 Core Assembly Removal, Wedge open the back cover: paso 2, imagen 2 de 2
    • Insert an opening tool between the back cover and the metal housing.

    • Twist the opening tool to create a wider gap.

    • Don't fully remove the back cover just yet. The sensor flex cable is still connected to the motherboard.

  3. Core Assembly Removal, Disconnect the sensor flex cable: paso 3, imagen 1 de 3 Core Assembly Removal, Disconnect the sensor flex cable: paso 3, imagen 2 de 3 Core Assembly Removal, Disconnect the sensor flex cable: paso 3, imagen 3 de 3
    • Lay the watch face down.

    • Carefully lift the back cover up from the edge with the buttons to access the sensor connector.

    • Use the flat end of a spudger to pry up and disconnect the sensor flex cable from the motherboard.

  4. Core Assembly Removal, Remove the back cover: paso 4, imagen 1 de 2 Core Assembly Removal, Remove the back cover: paso 4, imagen 2 de 2
    • Remove the back cover.

    • Make sure the rubber gasket (marked red) is undamaged. If damaged replace it with a new one during reassembly to maintain proper water resistance.

  5. Core Assembly Removal, Unplug the display connector: paso 5, imagen 1 de 2 Core Assembly Removal, Unplug the display connector: paso 5, imagen 2 de 2
    • Use the flat end of a spudger to pry up and disconnect the display flex cable from the motherboard.

  6. Core Assembly Removal, Loosen the core assembly: paso 6, imagen 1 de 2 Core Assembly Removal, Loosen the core assembly: paso 6, imagen 2 de 2
    • The core's plastic frame fits tightly within the watch's metal housing.

    • Place the corner of the flat end of a spudger in the small opening of the barometric sensor, on the opposite side of the display connector.

    • Twist and tilt the spudger to lever the core assembly out of the metal housing.

  7. Core Assembly Removal, Remove the core assembly: paso 7, imagen 1 de 3 Core Assembly Removal, Remove the core assembly: paso 7, imagen 2 de 3 Core Assembly Removal, Remove the core assembly: paso 7, imagen 3 de 3
    • Carefully thread the display flex cable through the gap on the core's plastic frame.

    • Remove the core assembly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Tobias Isakeit

Miembro Desde 03/31/14

116,710 Reputación

188 Guías creadas

Equipo

Master Techs Miembro de Master Techs

Community

322 Miembros

2,506 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 14

Todo El Tiempo: 934