Introducción
For a sticky Cold Shot button, you may only need to clean the button. This guide will show you how to fully remove and replace the button.
Note: This guide requires soldering skills. If you don't know how to solder or want to brush up on your skills check out this handy tutorial.
Qué necesitas
-
-
-
Hold the hair dryer by the nozzle so that the handle points to the left.
-
Remove the two 1-inch Phillips #2 screws from the back of the fan motor.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
2 personas más completaron esta guía.