Repara tus cosas Comunidad Tienda

Computer King Muffin Kinder 7 Logic Board Replacement

Introducción

To complete this guide, you will need to disassemble your device and use a soldering iron to replace all the wires from the logic board.

Make sure to power off the device before you begin to take apart your device. Not doing so could potentially cause harm.

Qué necesitas

  1. Computer King Muffin Kinder 7 Logic Board Replacement, Logic Board: paso 1, imagen 1 de 2 Computer King Muffin Kinder 7 Logic Board Replacement, Logic Board: paso 1, imagen 2 de 2

    • Use the plastic opening tool help push out the microSD card from the microSD slot.

    Traducir

  2. Computer King Muffin Kinder 7 Logic Board Replacement: paso 2, imagen 1 de 1

    • Use the plastic opening tool to unclip the plastic front from the plastic back. Use the MicroSD slot to initially start the unclipping.

    Traducir

  3. Computer King Muffin Kinder 7 Logic Board Replacement: paso 3, imagen 1 de 2 Computer King Muffin Kinder 7 Logic Board Replacement: paso 3, imagen 2 de 2

    • Unscrew the nine 3.0 mm Phillips #00 screws.

    Traducir

  5. Computer King Muffin Kinder 7 Logic Board Replacement: paso 4, imagen 1 de 1

    • The battery is glued onto the black plastic. Use the plastic opening tool to pry the battery from the black plastic

    Traducir

  6. Computer King Muffin Kinder 7 Logic Board Replacement: paso 5, imagen 1 de 3 Computer King Muffin Kinder 7 Logic Board Replacement: paso 5, imagen 2 de 3 Computer King Muffin Kinder 7 Logic Board Replacement: paso 5, imagen 3 de 3

    • Unsolder the 11 red, back, and grey wires connected to the logic board.

    • Tips on how to solder can be found here.

    Traducir

  7. Computer King Muffin Kinder 7 Logic Board Replacement: paso 6, imagen 1 de 3 Computer King Muffin Kinder 7 Logic Board Replacement: paso 6, imagen 2 de 3 Computer King Muffin Kinder 7 Logic Board Replacement: paso 6, imagen 3 de 3

    • Use the flat end of the spudger to lift the black panels covering the three ribbon cables connected to the logic board.

    Traducir

  8. Computer King Muffin Kinder 7 Logic Board Replacement: paso 7, imagen 1 de 1

    • Pull the three ribbon cables out so that they are no longer connected to the logic board.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 3 otros colaboradores

Katherine

Miembro Desde 01/22/15

439 Reputación

3 Guías creadas

Insignias: 11

+ 8 más insignias

Equipo

UWT Liner: Group 2 Miembro de UWT Liner: Group 2

Community

4 Miembros

7 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 233