Repara tus cosas Comunidad Tienda

ColecoVision Controller Port Replacement

Introducción

The purpose of this guide is to communicate steps on how to replace or repair the controller ports on a ColecoVision.

Qué necesitas

  1. ColecoVision Controller Port Replacement, Controller Port: paso 1, imagen 1 de 1

    • Flip the ColecoVision over with the pegs facing the ceiling.

    • Remove the eight 15mm screws holding the bottom of the ColecoVision in place using the Phillips #1 screwdriver.

    Editar

  2. ColecoVision Controller Port Replacement: paso 2, imagen 1 de 2 ColecoVision Controller Port Replacement: paso 2, imagen 2 de 2

    • Carefully remove the bottom of the ColecoVision out of the top.

    • I would recommend running a metal spudger along the rim of the case to remove the bottom.

    Editar

  4. ColecoVision Controller Port Replacement: paso 3, imagen 1 de 2 ColecoVision Controller Port Replacement: paso 3, imagen 2 de 2

    • Remove the two 15mm screws holding the casing in place using the Phillips #1 screwdriver.

    • Remove the casing and put it to the side.

    Editar

  5. ColecoVision Controller Port Replacement: paso 4, imagen 1 de 2 ColecoVision Controller Port Replacement: paso 4, imagen 2 de 2

    • Remove the two 15mm screws on the motherboard with a Phillips #1 screwdriver.

    • Pull the entire motherboard towards the back of the system and carefully lift the entire motherboard.

    Editar

  6. ColecoVision Controller Port Replacement: paso 5, imagen 1 de 3 ColecoVision Controller Port Replacement: paso 5, imagen 2 de 3 ColecoVision Controller Port Replacement: paso 5, imagen 3 de 3

    • Flip the motherboard over and locate the two controller ports.

    • Using a soldering iron, desolder the controller ports.

    • Refer to this soldering technique guide for reference.

    • After waiting for controller ports to cool down, flip motherboard back over and carefully lift controller ports to remove.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 1 otro colaborador

Bobby

Miembro Desde 10/17/18

380 Reputación

2 Guías creadas

Insignias: 12

+ 9 más insignias

Equipo

UW Tacoma, Team S1-G2, Rose Fall 2018 Miembro de UW Tacoma, Team S1-G2, Rose Fall 2018

UWT-ROSE-F18S1G2

4 Miembros

12 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 3

Ultimos 30 días: 17

Todo El Tiempo: 832