Saltar al contenido principal

ColecoVision Cartridge Reader Replacement

Qué necesitas

  1. ColecoVision Cartridge Reader Replacement, Cartridge Reader: paso 1, imagen 1 de 1
    • Flip the console upside down and remove the eight 15mm Phillips #1 screws.

  2. ColecoVision Cartridge Reader Replacement: paso 2, imagen 1 de 2 ColecoVision Cartridge Reader Replacement: paso 2, imagen 2 de 2
    • Use the metal spudger along the bottom rim of the front panel to safely remove the top of the console. Set aside the top.

  3. ColecoVision Cartridge Reader Replacement: paso 3, imagen 1 de 2 ColecoVision Cartridge Reader Replacement: paso 3, imagen 2 de 2
    • Remove the two 15mm Phillips #1 screws holding the casing in place.

    • Remove the casing to reveal the cartridge reader.

  4. ColecoVision Cartridge Reader Replacement: paso 4, imagen 1 de 3 ColecoVision Cartridge Reader Replacement: paso 4, imagen 2 de 3 ColecoVision Cartridge Reader Replacement: paso 4, imagen 3 de 3
    • Desolder the sides of the cartridge reader using the soldering iron and desolder pump.

    • Refer to this soldering technique guide for reference

    • Patiently wait for the cartridge reader to cool down after being desoldered.

    • It's very important to remove all the tin from the motherboard and cartridge reader before lifting it from the motherboard. Failure to do so could damage the motherboard.

    • Carefully lift up the cartridge reader. A plastic spudger might be helpful in order to easily remove the cartridge reader.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Anastazia Kidder

Miembro Desde 10/17/18

109 Reputación

1 Guía escrita

Equipo

UW Tacoma, Team S1-G2, Rose Fall 2018 Miembro de UW Tacoma, Team S1-G2, Rose Fall 2018

UWT-ROSE-F18S1G2

4 Miembros

12 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 2

Ultimos 30 días: 19

Todo El Tiempo: 1,424