Press the eject button to view the laser inside.
  • Press the eject button to view the laser inside.

  • Using the blue plastic tool and the tweezers, remove the ribbon cable.

Agregar Comentario

Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.
  • Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.

  • Do not lift the top of the DVD player too quickly because there are wires attached on the inside.

  • Pry the top of the device open from the right side where the buttons are located.

Agregar Comentario

  • When pulling the ribbon cables out, make sure not to pull by the wires, as this can cause damage to them.

  • Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board.

Agregar Comentario

  • Take the top portion of the DVD player and orient the device as shown in the first picture.

  • Remove the four 0.2" screws circled in red.

Agregar Comentario

  • Losen the screw circled in red.

  • The screw will not come out of the plastic knob.

  • Turn the plastic knob 90 degrees to the right so that the cable comes out freely.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Yufay Chow

Miembro Desde 23/01/12

92 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 10-36, Amido Winter 2012 Miembro de Cal Poly, Team 10-36, Amido Winter 2012

CPSU-AMIDO-W12S10G36

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 325