Saltar al contenido principal

Cisco 878 Integrated Services Router Top Cover Disassembly

Qué necesitas

  1. Cisco 878 Integrated Services Router Top Cover Disassembly, Remove the two screws on back side: paso 1, imagen 1 de 3 Cisco 878 Integrated Services Router Top Cover Disassembly, Remove the two screws on back side: paso 1, imagen 2 de 3 Cisco 878 Integrated Services Router Top Cover Disassembly, Remove the two screws on back side: paso 1, imagen 3 de 3
    • Only trained and qualified personnel should be allowed to install, replace, or service this equipment!

    • During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself!

    • Make sure that the power switch is turned to standby and that the power supply cable is disconnected. Disconnect all cables from the router back panel.

    • Use the Phillips #1 Screwdriver to remove the two screws on back side of the device.

  2. Cisco 878 Integrated Services Router Top Cover Disassembly, Remove top cover: paso 2, imagen 1 de 3 Cisco 878 Integrated Services Router Top Cover Disassembly, Remove top cover: paso 2, imagen 2 de 3 Cisco 878 Integrated Services Router Top Cover Disassembly, Remove top cover: paso 2, imagen 3 de 3
    • 1. Gently push the top cover of the router away from you.

    • 2. Lift it up top cover from the bottom of the router.

    • 3. Remove top cover from the device.

    • Place the router bottom on an antistatic mat.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Jiri Altman

Miembro Desde 05/03/16

1,515 Reputación

9 Guías creadas

Equipo

4k20 Repair Team Miembro de 4k20 Repair Team

Community

2 Miembros

17 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 4

Todo El Tiempo: 237