Partes

No se requieren partes.

Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the top side.
  • Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the top side.

Agregar Comentario

Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the bottom side.
  • Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the bottom side.

  • Remove the warranty sticker across the bottom.

Agregar Comentario

  • Gently lift off the back and front casing.

  • The outer shell should easily come apart.

Agregar Comentario

  • Make sure the device screen is face down.

Agregar Comentario

  • Using the plastic opening tool, wedge the tool underneath the bottom left edge of the hard drive.

  • Raise the bottom edge of the hard drive 15 degrees up from the device.

Agregar Comentario

  • Place fingers on the IDE connectors and gently slide the hard drive out from the IDE module.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Ryan Sutardji

Miembro Desde 29/06/12

171 Reputación

7 Guías creadas

Equipo

Cal Poly, Team 1-4, Regan SU 2012 Miembro de Cal Poly, Team 1-4, Regan SU 2012

CPSU-REGAN-SU12S1G4

4 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 805