Saltar al contenido principal

Introducción

Sharpening is essentially what the chef's choice is about. This is achieved by the sharpening stones and will frequently need to be replaced. Extra caution to be taken on the removal of the c-clips as they can easily spring out and get lost.

Partes

No se especificaron partes.

  1. Chef's Choice M115 Sharpening Stones Replacement, Case: paso 1, imagen 1 de 2 Chef's Choice M115 Sharpening Stones Replacement, Case: paso 1, imagen 2 de 2
    • Remove the two rubber feet on the motor side of the device.

    • Remove the five Phillips screws from the bottom of the case.

    • These screws are recessed deep in the device, so a long, thin screwdriver is required.

  2. Chef's Choice M115 Sharpening Stones Replacement: paso 2, imagen 1 de 1
    • Remove the two hex-cap screws on the bottom using a pair of pliers.

  3. Chef's Choice M115 Sharpening Stones Replacement: paso 3, imagen 1 de 1
    • Carefully flip the device right-side-up while grasping the top and bottom pieces.

    • The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

  4. Chef's Choice M115 Sharpening Stones Replacement: paso 4, imagen 1 de 1
    • Remove the sharpener guard by gently pulling up on it.

    • If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

  5. Chef's Choice M115 Sharpening Stones Replacement, Sharpening Stones: paso 5, imagen 1 de 2 Chef's Choice M115 Sharpening Stones Replacement, Sharpening Stones: paso 5, imagen 2 de 2
    • With the outer case removed, firmly grasp the motor-axle attachment and remove it from the base. It should come right off of the assembly.

  6. Chef's Choice M115 Sharpening Stones Replacement: paso 6, imagen 1 de 2 Chef's Choice M115 Sharpening Stones Replacement: paso 6, imagen 2 de 2
    • Use a screwdriver to push the linkage pins out of the rod.

    • Use pliers to pull the pins the rest of the way out.

    • Remove all the linkage pins necessary to slide desired sharpening stone off the end of the shaft.

  7. Chef's Choice M115 Sharpening Stones Replacement: paso 7, imagen 1 de 3 Chef's Choice M115 Sharpening Stones Replacement: paso 7, imagen 2 de 3 Chef's Choice M115 Sharpening Stones Replacement: paso 7, imagen 3 de 3
    • On the rotating apparatus, holding the sharpening stones in place, are two C-clamps that grip the axle.

    • Remove the C-clamps by applying pressure to both sides of the "C" and pushing the clamp over and off of the axle.

    • Pull the bearing off the shaft. It is in between the two C-clamps.

    • These clamps are very small; use caution to avoid dropping them on the ground or losing them.

  8. Chef's Choice M115 Sharpening Stones Replacement: paso 8, imagen 1 de 1
    • Pull sharpening stones off the end of the shaft.

    • Be sure to remember the order and placement of each individual stone so you can reassemble them in the same order.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Zachary Nagel

Miembro Desde 17/09/15

116 Reputación

1 Guía escrita

Equipo

IUPUI, Team 3-3, Harley Fall 2015 Miembro de IUPUI, Team 3-3, Harley Fall 2015

IUPUI-HARLEY-F15S3G3

5 Miembros

12 Guías creadas

Un comentario

where does one get the replacement stones. im not seeing they in my amazon/google searches. also cant seem to see them on manufacturers website section for parts.

john molloy - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 13

Ultimos 30 días: 71

Todo El Tiempo: 3,463