Saltar al contenido principal

Introducción

A loose or faulty power switch should be replaced immediately. This can be a fire hazard due to an electrical short or choking hazard if it got loose and fell into the hands of an infant. This guide will show you how to prevent this from happening.

Partes

No se especificaron partes.

  1. Chef's Choice M115 Power Switch Replacement, Case: paso 1, imagen 1 de 2 Chef's Choice M115 Power Switch Replacement, Case: paso 1, imagen 2 de 2
    • Remove the two rubber feet on the motor side of the device.

    • Remove the five Phillips screws from the bottom of the case.

    • These screws are recessed deep in the device, so a long, thin screwdriver is required.

  2. Chef's Choice M115 Power Switch Replacement: paso 2, imagen 1 de 1
    • Remove the two hex-cap screws on the bottom using a pair of pliers.

  3. Chef's Choice M115 Power Switch Replacement: paso 3, imagen 1 de 1
    • Carefully flip the device right-side-up while grasping the top and bottom pieces.

    • The white cover should lift off with no resistance. If it does not, ensure all screws were removed in previous step.

  4. Chef's Choice M115 Power Switch Replacement: paso 4, imagen 1 de 1
    • Remove the sharpener guard by gently pulling up on it.

    • If the sharpener guard does not come off easily, ensure all screws were removed in step 1.

  5. Chef's Choice M115 Power Switch Replacement, Power Switch: paso 5, imagen 1 de 1
    • Carefully lift the entire motor assembly out of the case.

  6. Chef's Choice M115 Power Switch Replacement: paso 6, imagen 1 de 2 Chef's Choice M115 Power Switch Replacement: paso 6, imagen 2 de 2
    • Using a screw driver, unclip the edges of the switch by pushing them inwards and nudging the switch out of the plastic casing. You will hear a click when the edges unhook from the casing.

  7. Chef's Choice M115 Power Switch Replacement: paso 7, imagen 1 de 2 Chef's Choice M115 Power Switch Replacement: paso 7, imagen 2 de 2
    • Remove the spade connectors from the switch by pulling only on the connector, not the wire.

    • This may require a fair bit of force. Use caution to not damage the device, yourself, or your surroundings.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Equipo

IUPUI, Team 3-3, Harley Fall 2015 Miembro de IUPUI, Team 3-3, Harley Fall 2015

IUPUI-HARLEY-F15S3G3

5 Miembros

12 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 223