Casio Exilim EX-Z80 Back and Front Cover Replacement

Introducción

This guide will allow you to properly replace the front and back panel of the Casio Exilim EX-Z80 camera. This will also allow you to access the inner parts of the camera in the case that the lens or motherboard need to be replaced.

Qué necesitas

Paso 1 Battery

Casio Exilim EX-Z80 Back and Front Cover Replacement, Battery: paso 1, imagen 1 de 2

Casio Exilim EX-Z80 Back and Front Cover Replacement, Battery: paso 1, imagen 2 de 2

Locate the battery compartment at the bottom of the camera.
With your thumb, gently press down on the compartment door and slide to the left to open.

Editar

Paso 2

With your index finger, gently pull back gray release lever for the battery to pop out.
Gently pull the battery out of the slot.

Editar

Paso 3 Back and Front Cover

Casio Exilim EX-Z80 Back and Front Cover Replacement, Back and Front Cover: paso 3, imagen 1 de 3

Casio Exilim EX-Z80 Back and Front Cover Replacement, Back and Front Cover: paso 3, imagen 2 de 3

Casio Exilim EX-Z80 Back and Front Cover Replacement, Back and Front Cover: paso 3, imagen 3 de 3

Remove the four 3 mm black screws from the bottom of the camera using a Phillips #000 screwdriver.
Open the battery compartment with your thumb or index finger.
Remove the single 2 mm silver screw that is now exposed using a Phillips #000 screwdriver.

Editar

Paso 4

Casio Exilim EX-Z80 Back and Front Cover Replacement: paso 4, imagen 3 de 3

Open the USB port tab.
Remove the single 2 mm silver screw using a Phillips #000 screwdriver.

Editar

Paso 5

Remove the two 2 mm silver screws using a Phillips #000 screwdriver.

Editar

Paso 6

Carefully remove the silver strip from left side. Open the battery cover and remove the metal strip with fingers by sliding it to the left.

Editar

Paso 7

With the metal spudger, pry out the edge of the silver strip at the bottom right side of the camera.
Carefully remove the remaining part of the metal strip.

Editar

Paso 8

Remove the two 2 mm silver screws from the top corners of the camera using a Phillips #000 screwdriver.
Remove the three 2 mm screws from the left side using a Phillips #000 screwdriver.

Editar

Paso 9

Casio Exilim EX-Z80 Back and Front Cover Replacement: paso 9, imagen 3 de 3

Using a small opening tool carefully release all lock tabs at the top and on the side of the camera from their locked position.
Using your hands, carefully separate the front and back panel from the camera.

Editar