Flip the device over to the back side.
  • Flip the device over to the back side.

Agregar Comentario

Slide the small switch on the back to "MAIN".
  • Slide the small switch on the back to "MAIN".

Agregar Comentario

  • Slide the battery cover downwards.

  • Pull off the battery cover.

Agregar Comentario

  • Pull the black tab to remove the battery.

Agregar Comentario

  • Using the Phillips #00 screwdriver, remove the two screws near the top of the device.

Agregar Comentario

  • Using the Phillips #00 screwdriver, remove the two screws located inside the battery compartment.

Agregar Comentario

  • Partially separate the two halves of the case by inserting the tip of a small flat head screw driver into the space between the halves.

Agregar Comentario

  • Pry the two halves of the case apart with the small flat head screwdriver.

Agregar Comentario

  • Caution: be careful not to pull out the wires connecting the two halves of the outer case. These wires are necessary for the device to be able to function.

  • Lay the two halves of the outer case next to the central components as shown.

Agregar Comentario

  • Using the #00 Phillips screwdriver, remove the screws from the corners of the screen. There are 3 screws total.

Agregar Comentario

  • Lift the tab on the motherboard and pull out the ribbon cable.

  • After the ribbon cable is detached from the motherboard, the touch screen is completely separated from the device.

Agregar Comentario

  • Locate the small grey ribbon cable towards the bottom of the device. It should be located above the battery slot. Pinch both sides of the ribbon cable and pull it out.

Agregar Comentario

  • Locate the multicolored wire on the motherboard near the battery compartment. Pull on the wire by the base and lift to remove.

Agregar Comentario

  • Use the Phillips #00 Screwdriver to remove the two screws from the green circuit board on the back case.

Agregar Comentario

  • Remove the the three screws on the motherboard that are shown using the Phillips #00 Screwdriver.

Agregar Comentario

  • Caution: do not break ribbon cables from the motherboard because this may cause damage to your device.

  • Flip the motherboard towards the front cover to expose the ribbon cables underneath.

Agregar Comentario

  • Locate the two ribbon cables on the motherboard. Select one to remove first and then pinch either side of it and pull out to remove the ribbon cable. Do the same for the second.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Ryan Fernandez

Miembro Desde 03/04/12

47 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 5-4, Forte Spring 2012 Miembro de Cal Poly, Team 5-4, Forte Spring 2012

CPSU-FORTE-S12S5G4

6 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 783