Partes

No se requieren partes.

Flip the keyboard upside down so the bottom is angled towards you.
  • Flip the keyboard upside down so the bottom is angled towards you.

Agregar Comentario

Use a #2 Phillips screwdriver to remove the twenty-seven 12 mm screws from the dark gray bottom panel.
  • Use a #2 Phillips screwdriver to remove the twenty-seven 12 mm screws from the dark gray bottom panel.

Agregar Comentario

  • Remove the bottom panel by lifting the bottom panel up and outward from yourself.

Agregar Comentario

  • Flip the entire keyboard so the keys face up, and be careful not to let the bottom drop.

  • Flip the top half of the keyboard and set onto the bottom half with the internal parts facing up.

Agregar Comentario

  • Plug in the soldering iron and set it somewhere safe where it can't catch anything on fire.

  • Unscrew the top green circuit board with black and red wires running into it.

Agregar Comentario

  • Set the circuit board somewhere flat so it is safe to solder.

Agregar Comentario

  • Heat up the solder covering the end of the wires connected to the circuit board. Once the solder melts, remove the wires from the circuit board.

Agregar Comentario

  • Melt new solder with your soldering iron, then apply it over the tip of the wire touching the circuit board.

Agregar Comentario

  • Once the wires are firmly attached screw the circuit board back onto the keyboard.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Jimmy Winne

Miembro Desde 04/10/12

422 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 9-16, Amido Fall 2012 Miembro de Cal Poly, Team 9-16, Amido Fall 2012

CPSU-AMIDO-F12S9G16

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 6

Últimos 30 Días: 30

Todo El Tiempo: 2,373