Introducción

The motherboard controls the operations of the camera. Damage to the motherboard requires an entirely new motherboard.

Partes

No se requieren partes.

Slide grey latch to open the battery compartment.
  • Slide grey latch to open the battery compartment.

Agregar Comentario

Push orange retaining clip to the right to free battery.
  • Push orange retaining clip to the right to free battery.

Agregar Comentario

  • Remove battery from the camera.

Agregar Comentario

  • Remove the lanyard.

Agregar Comentario

  • Remove the two 2.3mm screws (underneath the name plate) and two 2.8mm screws (next to the threaded tripod mount) from the bottom face of the camera.

  • Be careful to keep track of the different screw sizes as you proceed with this guide.

Agregar Comentario

  • Remove the single 3.8mm screw from the back face of the camera.

Agregar Comentario

  • Remove the two 2.3mm screws from the right face of the camera.

Agregar Comentario

  • Remove the two 3.2mm screws (outside edge) and two 3.7mm screws (towards middle) from the left side of the camera body.

Agregar Comentario

  • Pull the back face panel away from the front end of the body. This may take some wiggling and force.

Agregar Comentario

  • Remove the CF card door from the left side of the camera body.

Agregar Comentario

  • Remove the rubber digital a/v out cap by sliding it out of the groove on the front plate.

Agregar Comentario

  • Remove the front face by sliding it off.

Agregar Comentario

  • Remove the rubber seal that goes over the right side of the viewfinder.

Agregar Comentario

  • Remove the two 3.9mm screws that retain the laminated cooper sheet.

Agregar Comentario

  • Remove the seven wire connections that connect to the motherboard.

Agregar Comentario

  • Remove the single 3.8mm screw that is on the motherboard.

Agregar Comentario

  • Carefully remove the motherboard from the main frame of the camera body.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Orlando Zuniga

Miembro Desde 14/04/11

11 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 20-70, Walters Spring 2011 Miembro de Cal Poly, Team 20-70, Walters Spring 2011

CPSU-WALTERS-S11S20G70

5 Miembros

4 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 2

Todo El Tiempo: 1,605