Canon PowerShot SX120 IS Back Cover Replacement

Introducción

Disassemble the back cover of the Canon PowerShot SX120 IS in order to open the camera and access the inside components.

Put the camera with the lens facing up and turn it to the side so the DC IN A/V OUT DIGITAL is facing you.
Remove the single black 3.4 mm screw with a Phillips #00 screwdriver.

Put the camera with the lens facing up, and turn it to the side where the battery cover is located.
Remove the three black 3.4 mm screws with a Phillips #00 screwdriver.

Put the camera with the lens facing up, turn it to the side where the compartment of the battery (CR1220) for time/date is located.
Remove the single black 3.4 mm screw with a Phillips #00 screwdriver.

Put the camera with the lens facing down, and turn it to the side where the DC IN A/V OUT DIGITAL cover and the silver lanyard attachment are located.
Open the DC IN A/V OUT DIGITAL cover.
Remove the single black 3.4 mm screw with a Phillips #00 screwdriver.

Turn the camera with the lens facing down.
Opening the camera can be challenging. Don't get discouraged if it takes you a few tries before the camera is opened.
Use the iFixit opening tool to make leverage. Insert the opening tool in the seam where the front case and the back case assemble.
Carefully put pressure on the opening tool so the cover can gradually open.
Slowly slide the opening tool along the gap and around the edge of the camera.
When you are dissembling the back cover, the DC IN A/V OUT DIGITAL cover will also disassemble and fall off.