Introducción

Remove the back cover before removing LCD.

Partes

No se requieren partes.

Remove one 2.25mm screw on the bottom.
  • Remove one 2.25mm screw on the bottom.

Agregar Comentario

Remove two 2.25mm screws on the right side looking from the front.
  • Remove two 2.25mm screws on the right side looking from the front.

Agregar Comentario

  • Remove one 4.7mm screw on the side with the AV output.

Agregar Comentario

  • Pull off the back cover.

  • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

Agregar Comentario

  • Remove 2 2.4mm screws on bottom.

Agregar Comentario

  • Follow the small data cable to where it connects to the camera.

  • Lift the back white portion to unlock the cable.

  • The cable should easily slide out.

  • The connector is very fragile. Use caution when lifting the lock.

Agregar Comentario

  • Gently lift LCD display off.

  • There will be two data cables still attached to the camera. Do not break them.

  • There may be a loose strip of metal along the inner side of the LCD display for a secure fit.

Agregar Comentario

  • Follow the larger cable to where it connects to the camera.

  • Lift the front black portion of the connector to unlock the data cable.

  • The cable should easily slide out.

  • The connector is very fragile. Use caution when lifting the lock.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Jeremy Rabaino

Miembro Desde 10/10/10

135 Reputación

6 Guías creadas

Equipo

Cal Poly, Team 20-9, Maness Fall 2010 Miembro de Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 Miembros

6 Guías creadas

where can I buy a replacement LCD screen for a SD800 IS

ALFRED - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 12

Todo El Tiempo: 2,088