Introducción

This guide provides instructions on how to replace the shutter button assembly on the Canon PowerShot S400.

Partes

No se requieren partes.

Unless otherwise stated,a #00 philips screwdriver will be used to remove screws.
  • Unless otherwise stated,a #00 philips screwdriver will be used to remove screws.

  • Remove the 4.75mm screw located in the top right corner of the backside of the camera.

  • Remove the four # screws located on the bottom of the camera.

Agregar Comentario

Remove the two screws located on the right side of the camera.(the side with the USB adaption plug)
  • Remove the two screws located on the right side of the camera.(the side with the USB adaption plug)

  • Remove the four screws on the left side of the camera.

  • This will release a small metal plate. Remove this plate.

Agregar Comentario

  • There is a small black plastic piece that sits above the lens underneath the camera case. This plastic piece may fall out when you remove the cases; recover the piece and save it.

  • Now separate the front and back camera casings.

Agregar Comentario

  • Using a spudger, carefully pry the shutter button assembly from the camera.

  • Install the replacement shutter button assembly.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Ross Bryan

Miembro Desde 21/01/11

350 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 5-19, Amido Winter 2011 Miembro de Cal Poly, Team 5-19, Amido Winter 2011

CPSU-AMIDO-W11S5G19

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 2,394