Introducción
The flash of the Canon PowerShot G3 camera is operated by the discharge of a capacitor. A capacitor is an energy storing device that stores a charge between two conducting plates. Before the capacitor can discharge, it must be charged by the battery.
Note:
1.) There are many screws to be removed before you can reach the capacitor.
2.) To install a new capacitor you must know how to solder wires to the capacitor.
3.) Do not continue unless you have a magnetic pad to place the screws and a soldering iron.
Qué necesitas
-
-
Start to remove all of the screws around the camera: from the front, back, sides, and bottom.
-
-
-
-
Use a spudger, or other thin object, to remove the capacitor from the housing. (Image 2)
-
To remove the red and yellow wires connected to the capacitor, use a soldering iron to heat up the solder and a vacuum to suck up the solder. Any other methods you know of will also work.
-
Take the capacitor to you local electronics store or order another capacitor online by reading the capacity off of the side of the capacitor. It should be in microFarads (µF).
-
Once you have a new capacitor, solder on the red and yellow wires to the same place as the old capacitor.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Equipo
University of Memphis, Team 3-2, Kim Fall 2015 Miembro de University of Memphis, Team 3-2, Kim Fall 2015
UM-KIM-F15S3G2
4 Miembros
5 Guías creadas
