Canon PowerShot ELPH 300HS Camera Case Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

Before you begin, make sure that you are in a relatively dust free environment with adequate space for the project. This guide involves lot of small screws, so it will also be helpful to have some way to keep track of them as well.

Qué necesitas

Paso 1 Safety First

Before you begin taking apart your device, the first, and MOST IMPORTANT STEPS are to:
Turn off your camera.
Remove the battery to prevent risk of shock.

Traducir

Paso 2 Remove the Battery

Canon PowerShot ELPH 300HS Camera Case Replacement, Remove the Battery: paso 2, imagen 1 de 2

Canon PowerShot ELPH 300HS Camera Case Replacement, Remove the Battery: paso 2, imagen 2 de 2

Turn off your camera by pressing the power button, located on the top-center of the device.
Locate the battery door on the bottom right area of the camera case.
Place your finger firmly on the black rubber pad on the battery door and slide the door to the right to open it.
Locate the orange battery release button beneath the battery door.
Slide the battery release button downward to release the battery.

Traducir

Paso 3 Left Side Screws

Canon PowerShot ELPH 300HS Camera Case Replacement, Left Side Screws: paso 3, imagen 1 de 1

Be careful when removing screws, as they are stripped easily.
Remove the two screws located on the left side of the camera case, using the Phillips screwdriver #00 (2.0 mm).

Traducir

Paso 4 Bottom Screws

Canon PowerShot ELPH 300HS Camera Case Replacement, Bottom Screws: paso 4, imagen 1 de 1

Remove the two screws on the bottom of the camera located near the battery door (Phillips #00 screwdriver) (4.0 mm).

Traducir

Paso 5 Right Side Screws

Canon PowerShot ELPH 300HS Camera Case Replacement, Right Side Screws: paso 5, imagen 1 de 1

Remove the screw located on the lower right side of the camera case (Phillips #00 screwdriver) (4.0 mm).
Remove the HDMI A/V out port cover located on the upper right side of the camera.
Remove the screw located just beneath the port cover removed in step 2. (Phillips #00 screwdriver) (2.0 mm).

Traducir

Paso 6

Remove the back portion of the camera case to reveal the screw located on the top of the case.
Remove the screw from the top of camera case, located next to the shutter button (Phillips #00 screwdriver) (1.5 mm).

Traducir

Paso 7 Remove the Case from the Camera

Canon PowerShot ELPH 300HS Camera Case Replacement, Remove the Case from the Camera: paso 7, imagen 1 de 3

Canon PowerShot ELPH 300HS Camera Case Replacement, Remove the Case from the Camera: paso 7, imagen 2 de 3

Canon PowerShot ELPH 300HS Camera Case Replacement, Remove the Case from the Camera: paso 7, imagen 3 de 3

Carefully pry the case apart at the seem, using your fingers.
Be careful not to over bend the small metal projections located along the seams. These aid in holding the case together.
Be careful not to allow dust or other particles to settle inside of the camera while the case is detached. This can cause functional issues in the future.