Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
While the switch is pushed forward, pull the cover away from the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To remove batteries, simply allow them to fall out of the camera.
-
Use a fingernail to lift the clock battery out of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the screw located under the rubber flap on the left side of the camera using a Phillips #00 screwdriver.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two screws located on the other side of the camera using a Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three screws located at the bottom of the camera using a Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the battery cover.
-
Using the iFixit opening tool, push up gently around all edges of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four screws near the corners of the LCD using a Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently lift the screen from the motherboard.
-
Keep the LCD pulled back in one hand.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Keep the LCD pulled back in one hand.
-
Use an iFixit opening tool to pull the black retaining clip up and disconnect the ribbon.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Desolder the wires from the back of the LCD located in the bottom left corner.
-
Remove the solder from the wires.
-
Separate the LCD from the rest of the camera.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.