Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
While the switch is pushed forward, pull the cover away from the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To remove batteries, simply allow them to fall out of the camera.
-
Use a fingernail to lift the clock battery out of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the screw located under the rubber flap on the left side of the camera using a Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two screws located on the other side of the camera using a Phillips #00 screwdriver.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three screws located at the bottom of the camera using a Phillips #00 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the battery cover.
-
Using the iFixit opening tool, push up gently around all edges of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Press and hold down the button shown in the blue circle.
-
While pressing the button, rotate the lens cover in a counter-clockwise direction to remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the one (1) screw from the top of the camera, on the left side of the flash (looking from the front) using a Phillips #00 screwdriver.
-
Lift the black plastic covering off the circuit board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the green circuit board from the top. Looking from the front of the camera, first lift the left side up above the black peg. The board should then slide out to the left.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The flash logic board can now be removed from the camera and replaced.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.
2 comentarios
If it is the flash element that needs to be replace, I presume I will see it when I’m there.
Is this correct ?
effitech_structure@yahoo.com