Repara tus cosas Comunidad Tienda

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Canon PowerShot A590 IS Back Cover Replacement

Introducción

You will remove screws from the bottom and sides of the camera in order to remove the cameras back cover.

Qué necesitas

  1. Canon PowerShot A590 IS Back Cover Replacement, Batteries: paso 1, imagen 1 de 2 Canon PowerShot A590 IS Back Cover Replacement, Batteries: paso 1, imagen 2 de 2

    • The battery hatch is on the bottom of the camera.

    • CAUTION: Locate the switch to open the hatch and push gently toward the front of the camera. Too much force can break the hatch.

    • While the switch is pushed forward, pull the cover away from the camera.

    Traducir

  2. Canon PowerShot A590 IS Back Cover Replacement: paso 2, imagen 1 de 1

    • This camera requires AA batteries.

    • To remove batteries, simply allow them to fall out of the camera.

    • Use a fingernail to lift the clock battery out of the camera.

    Traducir

  3. Canon PowerShot A590 IS Back Cover Replacement: paso 3, imagen 1 de 1

    • When replacing the AA batteries, verify they are oriented correctly by following the (+) and (-) signs on the camera.

    Traducir

  5. Canon PowerShot A590 IS Back Cover Replacement, Remove Screw Near AV Port: paso 4, imagen 1 de 1

    • Remove the screw located under the rubber flap on the left side of the camera using a magnetic screwdriver.

    Traducir

  6. Canon PowerShot A590 IS Back Cover Replacement, Remove Side Screws: paso 5, imagen 1 de 1

    • Remove the two screws located on the other side of the camera using a magnetic screwdriver

    Traducir

  7. Canon PowerShot A590 IS Back Cover Replacement, Remove Bottom Screws: paso 6, imagen 1 de 1

    • Remove the three screws located at the bottom of the camera using a magnetic screwdriver.

    Traducir

  8. Canon PowerShot A590 IS Back Cover Replacement, Remove Back Cover: paso 7, imagen 1 de 1

    • Open the battery cover.

    • Using the iPod tool, push up gently around all edges of the camera.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

7 personas más completaron esta guía.

Autor

con 9 otros colaboradores

Zach

Miembro Desde 10/11/10

281 Reputación

6 Guías creadas

Insignias: 12

+ 9 más insignias

Equipo

Cal Poly, Team 9-19, Regan Fall 2010 Miembro de Cal Poly, Team 9-19, Regan Fall 2010

CPSU-REGAN-F10S9G19

4 Miembros

14 Guías creadas

Un comentario

i just wanted to by flap to replace over batteries it slides on and off reedalice270@gm.com

Alice Reed - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 5

Ultimos 30 días: 16

Todo El Tiempo: 8,547