Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 7.9 mm screws using a Phillips #1 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the blue lever from its slot by pushing it back and twisting clockwise.
-
Close the scanner compartment and cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pry open the side cover with the plastic opening tool.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the printer over so that the bottom of the printer is facing you.
-
Use the plastic opening tool to remove the corner of the side panel from the plastic pin.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the plastic opening tool to loosen the side panel from the bottom of the printer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the plastic opening tool, pry off the top cover of the LCD assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After removing the top cover of the LCD assembly, remove the LCD using the plastic opening tool.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pull the ribbon cable to remove the LCD completely.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the plastic opening tool, gently pry under the button cover to remove it from its fixture.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the five 7.7 mm screws using a Phillips #1 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the plastic opening tool, gently pry around the cover behind the LCD screen to remove it from its fixture.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 7.8 mm screws using a Phillips #1 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pull the LCD screen up to remove it from its fixture.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the plastic opening tool to pry off the plastic button assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently pull the plastic button assembly up to remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the ribbon cable connected to the backside of the plastic button assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the seven 8.7 mm screws using the Phillips #1 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the spring that holds the PCB in place on the bottom left of the plastic button assembly.
-
Gently lift the spring and pull the board out of its plastic button assembly.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the buttons from the plastic button assembly.
-