Introducción

Use this guide to replace the grip of the camera.

Partes

No se requieren partes.

  1. Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
    • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

    Agregar Comentario

  2. On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
    • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

    • Pry up the panel; starting from the front/bottom corner, as indicated.

      • There's a concealed lip, under the opposite edge.

    Agregar Comentario

    • Remove three medium length screws from the bottom of the camera

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Remove the two medium length screws on the front panel of the camera above the lens mount.

    • Once you done, you may use the Spudger to panel from non-grip side.

    • If you start on the grip side, it will be more challenging to loosen the panel.

    Agregar Comentario

    • Remove the two 4.5mm (.18in) long black screws from the camera grip using a #00 Phillips screwdriver.

    Agregar Comentario

    • Use your fingertip to pry off the external shutter port cover.

    Agregar Comentario

    • Remove the two 5mm (.20in) long silver screws securing the grip to the camera using a #00 Phillips screwdriver.

    Agregar Comentario

    • Use the spudger tool to carefully pry the grip from the rest of the camera.

    Agregar Comentario

    • Once the grip is loose, use your fingers to remove it from the camera.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Daniel Bussone

Miembro Desde 28/01/11

1,215 Reputación

11 Guías creadas

Equipo

Cal Poly, Team 3-41, Regan Winter 2011 Miembro de Cal Poly, Team 3-41, Regan Winter 2011

CPSU-REGAN-W11S3G41

2 Miembros

11 Guías creadas

Little confused. Some pics are from a analog Canon, other from a digital Canon...

Gustavo Aguiar - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 3

Últimos 30 Días: 8

Todo El Tiempo: 3,060