Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the battery door/camera grip on the left side of the camera and lift the rotating removal tab.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Twist the tab clockwise to unlock the door, then pull outward from the camera to remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the battery from inside the battery housing and set the cover aside.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 6.4mm screws above the lens aperture using a phillips #00 screw driver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 6.4mm screw from the inside of the flash bezel.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the camera upside down and remove the 5.4mm screw below the lens bezel on the front of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove two 6.4mm screws on the latch mechanism on the right side of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 6.4mm screw on the top of the inside edge of the battery hole.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove two 4.8mm screws located on both sides of the eyepiece.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once you have revealed the ribbon cable, gently let the top cover hang off the front of the camera. Use the plastic opening tool to gently pull the white tabs on the ribbon cable, releasing the ribbon cable.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.