Introduction

Taking off the top of the camera allows repair access to the eye piece and command dial.

Parts

No parts required.

  1. Open up the battery door.
    • Open up the battery door.

    Add Comment

  2. Remove the batteries from the camera by sliding them out into your palm.
    • Remove the batteries from the camera by sliding them out into your palm.

    Add Comment

    • Release the side latch to open the back panel.

    Add Comment

    • Remove the two black 4.5mm screws above and below the latch.

    Add Comment

    • Using your finger, carefully pry open the side panel from the top of camera.

    • Pull panel downwards to remove.

    • Make sure to keep track of the small black piece of rubber under the latch.

    Add Comment

    • Remove the two silver 6mm Phillips #1 screws.

    Add Comment

    • Flip camera over to the bottom.

    • Remove the one 5mm Phillips #1 silver screw.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the front panel by pulling away from the side with the lever.

    Add Comment

    • Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.

    • Remove five black 4.8mm Phillips #1 screws.

    Add Comment

    • Simply remove the bottom panel by prying it off with your finger.

    • When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.

    • Be wary of a loose piece of foam attached to the bottom panel.

    Add Comment

    • Remove the remote control socket cover.

    Add Comment

    • Remove two black 4.5mm Phillips #1 screws.

    Add Comment

    • Remove two black 4.8mm Phillips #1 screws on the front of the camera.

    Add Comment

    • Pry open the side grip using a spudger.

    Add Comment

    • With your hands, remove the rubber grip from the eye piece.

    Add Comment

    • Remove the eyecup from the eyepiece by pushing the eyecup up.

    Add Comment

    • Remove two silver 5.0mm Phillips #1 screws.

    Add Comment

    • Remove the silver 5.5mm Phillips #1 screw.

    Add Comment

    • Pry the top silver part of the camera off.

    • Buttons may slip out of the camera's top as the top is pulled off the camera (shown in picture two).

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tammy Kong

Member since: 01/23/2014

643 Reputation

6 Guides authored

Team

Cal Poly, Team 6-20, Maness Winter 2014 Member of Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 Members

11 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 9

All Time: 298