Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two 4.8 mm black screws above the lens on the front of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 4.8 mm black screw on the left side of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the front panel by lifting it away from the camera's body.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the plastic remote control socket cap by pulling it straight out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide the panel toward the bottom of the camera to remove.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the single 4.8 silver screw from the control socket.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Desolder connections to replace the remote control socket.
-
3 comentarios
i have this camera and the door that holds the film in will not stay closed because the plastic piece has broken at the release point. Which piece is it that I need to replace?
That's a bit of a bugger. The piece that's broken off is most likely the little "hook" on the "door" (the proper name of this "door" would be "back").
Since this little hook is integral with the back, you'd have to replace the entire back.
If you still have the piece that has broken off, it may be possible to glue it back in place, but you'd have to reinforce it with e.g. a small piece of aluminium sheet cut from a soft drink can or something like that. Use cyanoacrylate glue (otherwise known as "superglue") and make sure the pieces are clean and fit perfectly before applying the glue. You need only a tiny drop.
The EOS 30 is a film camera and therefore does not have an A/V Port, since it does neither Audio nor Video. The socket near the bottom on the grip side is for a wired remote control.