Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull up on both sides of the the eyepiece cap. It should come off with little pressure.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two screws hidden under the viewfinder eyepiece cap.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Peel off the rubber grip on the back by grasping one of the corners and pulling it away from the camera body.
-
Once removed, a hidden screw is revealed.
-
Remove both screws from the rear of the camera.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two indicated screws from the bottom of the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the lock on the flex cable connector up with a spudger.
-
The front panel should pop off, now that the cable has been disconnected.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect all the indicated connectors by opening their latches.
-
Remove the flex cable that connects the logic board to the secondary control board.
-
Pull the small green connector out of its socket. Be careful when removing it, as it is possible to tear the tiny wires running into the connector.
-
Disconnect the two hidden connectors under the top connector indicated in pink.
-
Disconnect the third hidden connector.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three screws from the edges of the board.
-
Flip the board up and out so that the ground connection can be unscrewed.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Open the connector for the CF slot.
-
Remove the screw that attaches the bottom of the CF slot.
-
Remove the two last screws attaching the top of the CF slot.
-
Remove the CF slot.
-
Cancelar: No complete esta guía.
5 personas más completaron esta guía.
