Saltar al contenido principal

CanoScan LiDE 35 Scanner Bar Replacement

Qué necesitas

  1. CanoScan LiDE 35 Scanner Bar Replacement, Scanner Glass: paso 1, imagen 1 de 3 CanoScan LiDE 35 Scanner Bar Replacement, Scanner Glass: paso 1, imagen 2 de 3 CanoScan LiDE 35 Scanner Bar Replacement, Scanner Glass: paso 1, imagen 3 de 3
    • Slide plastic opening tool under the plastic.

    • Gently pry the plastic framing off the glass.

    • Repeat on the other side.

  2. CanoScan LiDE 35 Scanner Bar Replacement: paso 2, imagen 1 de 2 CanoScan LiDE 35 Scanner Bar Replacement: paso 2, imagen 2 de 2
    • Remove the front plastic frame.

  3. CanoScan LiDE 35 Scanner Bar Replacement: paso 3, imagen 1 de 3 CanoScan LiDE 35 Scanner Bar Replacement: paso 3, imagen 2 de 3 CanoScan LiDE 35 Scanner Bar Replacement: paso 3, imagen 3 de 3
    • Wedge the plastic opening tool under the glass.

    • Pull up against glass.

    • Slide the glass forward.

    • Remove the glass.

  4. CanoScan LiDE 35 Scanner Bar Replacement, Scanner Bar: paso 4, imagen 1 de 1
    • Remove the scanner bar.

    • Replace the scanner bar back onto metal center bar.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Nick

Miembro Desde 10/28/13

143 Reputación

1 Guía escrita

Equipo

Un comentario

Hello Nick, thank you for the guide.
My CanoScan LiDE 220 has started to introduce a line down the middle of the page when I scan with VueScan. Not sure if this guide applies.

Mark Leung - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 7

Ultimos 30 días: 22

Todo El Tiempo: 1,815