Introducción

Follow this guide to remove and replace or repair the spout on a Bush pump.

Herramientas

No se requieren herramientas.

Partes

No se requieren partes.

  1. Test pump performance by pumping 40 strokes.
    • Test pump performance by pumping 40 strokes.

    • An effective pump should return at least 10 liters.

    Agregar Comentario

  2. Remove the two pins connecting the handle to the slider.
    • Remove the two pins connecting the handle to the slider.

    Agregar Comentario

    • Pull the two lever arms away from the slider.

    Agregar Comentario

    • Lift the two pins attaching the pump frame to the head and handle up, off of the pump frame.

    Agregar Comentario

    • Throughout this step, make sure you support the handle and head with at least three hands.

    • Slide the bearing rod out of the head.

    • Inspect the bearing rod and head for any wear or tear.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Remove the head and handle, and place them on a clean surface to prevent contamination.

    Agregar Comentario

    • Firmly lift the riser main slider with two hands.

    • Use caution not to drop the riser main, as this can damage the pump cylinder.

    Agregar Comentario

    • Use a pipe wrench to fully loosen the above grade riser pipe.

    Agregar Comentario

    • Lift the slider and riser main pipe.

    • Place a pump rod clamp around the rod, and tighten it securely against the pump rod.

    • Carefully lower the riser main and slider to allow it to rest on the rod clamp.

    Agregar Comentario

    • Loosen and remove both the pump rod jam nut and pump rod nut on the top of the slider.

    Agregar Comentario

    • Remove the riser main slider, and inspect it for wear and tear.

    • Set the slider in a sanitary place to prevent contamination.

    Agregar Comentario

    • Remove the above grade riser pipe.

    • Firmly screw a T-handle onto the pump rod.

      • If you are replacing the above ground riser main, leave the T-handle attached until you are ready to install the replacement part.

    Agregar Comentario

    • Use a pipe wrench to loosen and remove the pump spout.

    • Inspect the spout for obstructions or potential contaminants.

    • Place the spout on a clean surface to prevent any contamination.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Jake Devincenzi

Miembro Desde 18/04/11

106,610 Reputación

57 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 99