Introducción

This guide will show how to remove and replace the browning dial/circuit of the Brentwood TS-292B.

Partes

No se requieren partes.

  1. Remove the five screws indicated using a Philips head screwdriver.
    • Remove the five screws indicated using a Philips head screwdriver.

  2. Pull hard on the browning lever until it detaches from the toaster.
    • Pull hard on the browning lever until it detaches from the toaster.

    • It will take some force to pull it off.

    • Once the tab is off, lift up on the housing to remove it from the toaster.

    • Once the housing has been pulled upwards, carefully uplug the wire connecting the browning dial circuit board to the main circuit board.

    • There are four screws on the circuit board for the browning dial.

    • Unscrew each of them with a Philips head screwdriver to detach the board and remove the board and dial from the toaster housing.

    • There are two holes on the board where the pin from the browning dial can align.

    • Refer to the images if you are having trouble finding them.

    • Replace the browning dial by inserting the pin on the dial into one of the holes indicated.

    • Replace the entire circuit board if need be.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 25

Todo El Tiempo: 49