Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the blue plastic opening tool, pry up on the cloth covered end panel. The edge of end cap cover should separate from main body of device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using your fingers, lift up on the end cap cover until it separates completely from the main body of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 4, PH1, 15mm screws on the side speaker cover frame.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove speaker cover frame from main body of device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the 4, PH1, 10 mm screws from the subwoofer frame.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the blue plastic opening tool, pry up on the edge of the subwoofer frame.
-
Using your fingers, lift up on the subwoofer frame until it separates completely from the main body of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the curved precision tweezers, grasp end of wire.
-
Using the curved precision tweezers, unravel wire around blue metal post.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After wire is completely unraveled, repeat steps 4 and 5, on red metal post.
-
Remove the speaker from the device.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.