Saltar al contenido principal

Introducción

The Bose Cinemate 10 contains four subwoofers throughout the whole console. This replacement guide is for the two subwoofers that are located on the soundbar's left and right side.

Partes

No se especificaron partes.

  1. Using the blue plastic opening tool, pry up on the cloth covered end panel. The edge of end cap cover should separate from main body of device. Using the blue plastic opening tool, pry up on the cloth covered end panel. The edge of end cap cover should separate from main body of device.
    • Using the blue plastic opening tool, pry up on the cloth covered end panel. The edge of end cap cover should separate from main body of device.

  2. Using your fingers, lift up on the end cap cover until it separates completely from the main body of the device.
    • Using your fingers, lift up on the end cap cover until it separates completely from the main body of the device.

  3. Remove the 4, PH1, 15mm screws on the side speaker cover frame. Remove the 4, PH1, 15mm screws on the side speaker cover frame.
    • Remove the 4, PH1, 15mm screws on the side speaker cover frame.

  4. Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now

    Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now
  5. Remove speaker cover frame from main body of device.
    • Remove speaker cover frame from main body of device.

  6. Remove the 4, PH1, 10 mm screws from the subwoofer frame. Remove the 4, PH1, 10 mm screws from the subwoofer frame.
    • Remove the 4, PH1, 10 mm screws from the subwoofer frame.

  7. Using the blue plastic opening tool, pry up on the edge of the subwoofer frame. Using your fingers, lift up on the subwoofer frame until it separates completely from the main body of the device.
    • Using the blue plastic opening tool, pry up on the edge of the subwoofer frame.

    • Using your fingers, lift up on the subwoofer frame until it separates completely from the main body of the device.

  8. Using the curved precision tweezers, grasp end of wire. Using the curved precision tweezers, unravel wire around blue metal post. Using the curved precision tweezers, unravel wire around blue metal post.
    • Using the curved precision tweezers, grasp end of wire.

    • Using the curved precision tweezers, unravel wire around blue metal post.

  9. After wire is completely unraveled, repeat steps 4 and 5, on red metal post. Remove the speaker from the device.
    • After wire is completely unraveled, repeat steps 4 and 5, on red metal post.

    • Remove the speaker from the device.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 5

Últimos 30 Días: 19

Todo El Tiempo: 150