Saltar al contenido principal

Partes

No se especificaron partes.

  1. Este paso está sin traducir. Ayuda a traducirlo

    Before disassembling your remote, be sure it is powered off. Remove the four 17.57mm screws from the bottom of the case with a PH0 screwdriver. Remove the four 17.57mm screws from the bottom of the case with a PH0 screwdriver.
    • Before disassembling your remote, be sure it is powered off.

    • Remove the four 17.57mm screws from the bottom of the case with a PH0 screwdriver.

  2. Este paso está sin traducir. Ayuda a traducirlo

    Carefully separate the two halves of the casing by pulling them apart at the seam. Be sure to keep the scroll wheel, lever and buttons attached to the housing.
    • Carefully separate the two halves of the casing by pulling them apart at the seam.

    • Be sure to keep the scroll wheel, lever and buttons attached to the housing.

  3. Este paso está sin traducir. Ayuda a traducirlo

    Remove the rectangular black adhesive foam on top of the battery by peeling it away from the battery. Desolder the battery connections from the circuit board. Replace the dead battery with a new 3.7 volt lithium polymer battery.
    • Remove the rectangular black adhesive foam on top of the battery by peeling it away from the battery.

    • Desolder the battery connections from the circuit board.

    • Replace the dead battery with a new 3.7 volt lithium polymer battery.

    • Refer here for more information how to desolder the battery.

Linea de Meta

2 personas más completaron esta guía.

Kevin Manko

Miembro Desde 06/10/16

143 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 15-7, Livingston Fall 2016 Miembro de Cal Poly, Team 15-7, Livingston Fall 2016

CPSU-LIVINGSTON-F16S15G7

4 Miembros

6 Guías creadas

Un Comentario

Where can I get the battery? Or can you give specs? Thanks!

Dan Davie - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 13

Ultimos 30 días: 52

Todo El Tiempo: 3,171