Saltar al contenido principal

Boosted Board 1st Generation Rear Wheels Replacement

Qué necesitas

  1. Boosted Board 1st Generation Rear Wheels Replacement, Rear Wheels: paso 1, imagen 1 de 2 Boosted Board 1st Generation Rear Wheels Replacement, Rear Wheels: paso 1, imagen 2 de 2
    • Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench.

    • Do Not Remove the Screws.

  2. Boosted Board 1st Generation Rear Wheels Replacement: paso 2, imagen 1 de 1
    • Compress the motor mount back towards the wheel.

    • While keeping the motor mount compressed, tighten one of the hex nuts that you loosened in the previous step.

    • The motor mounts are spring tensioned so it is necessary compress them to loosen the belts.

  3. Boosted Board 1st Generation Rear Wheels Replacement: paso 3, imagen 1 de 2 Boosted Board 1st Generation Rear Wheels Replacement: paso 3, imagen 2 de 2
    • Remove the axel nut with a 1/2" socket wrench

  4. Boosted Board 1st Generation Rear Wheels Replacement: paso 4, imagen 1 de 3 Boosted Board 1st Generation Rear Wheels Replacement: paso 4, imagen 2 de 3 Boosted Board 1st Generation Rear Wheels Replacement: paso 4, imagen 3 de 3
    • Rotate and pull counterclockwise until the wheel comes off the axle completely.

    • The front washer will come off with the wheel.

    • Remove the back washer from the axle.

    • Replacing the wheel requires the bearings to be switched into the new wheel.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Emily Imfeld

Miembro Desde 10/06/16

532 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 15-7, Livingston Fall 2016 Miembro de Cal Poly, Team 15-7, Livingston Fall 2016

CPSU-LIVINGSTON-F16S15G7

4 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 4

Todo El Tiempo: 1,255