Saltar al contenido principal

Introducción

This guide will show you how to remove and replace the belts on your board. The rear motor is load with springs, so be carful and pay close attention to the steps when taking the board apart. If your belt is broken, you will need to buy a new one through Boosted. Happy fixing!

Herramientas

Partes

No se especificaron partes.

  1. Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench. Do Not Remove the Screws.
    • Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench.

    • Do Not Remove the Screws.

  2. Compress the motor mount back towards the wheel.
    • Compress the motor mount back towards the wheel.

    • While keeping the motor mount compressed, tighten one of the hex nuts that you loosened in the previous step.

    • The motor mounts are spring tensioned so it is necessary compress them to loosen the belts.

  3. Remove the axel nut with a 1/2" socket wrench Remove the axel nut with a 1/2" socket wrench
    • Remove the axel nut with a 1/2" socket wrench

  4. Rotate and pull counterclockwise until the wheel comes off the axle completely. The front washer will come off with the wheel. Remove the back washer from the axle.
    • Rotate and pull counterclockwise until the wheel comes off the axle completely.

    • The front washer will come off with the wheel.

    • Remove the back washer from the axle.

    • Replacing the wheel requires the bearings to be switched into the new wheel.

  5. Compress the motor mount back . Slide the belt off the axle Slide the belt off the axle
    • Compress the motor mount back .

    • Slide the belt off the axle

  6. Remove the two hex screws.
    • Remove the two hex screws.

    • Remove the front hex screw.

    • When removing the Front hex screw, hold the motor mount and the truck together.

    • The springs inside the motor mount will push the motor out of the casing if they are not held together.

  7. Making sure to hold the motor and truck together, lift off the belt casing and take off the belt. Do Not let go of the motor and truck until the new belt is on and the Front hex screw is tightened securely. The springs inside the motor mount will push the motor out of the casing if they are not held together.
    • Making sure to hold the motor and truck together, lift off the belt casing and take off the belt.

    • Do Not let go of the motor and truck until the new belt is on and the Front hex screw is tightened securely.

    • The springs inside the motor mount will push the motor out of the casing if they are not held together.

Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Emily Imfeld

Miembro Desde 06/10/16

514 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 15-7, Livingston Fall 2016 Miembro de Cal Poly, Team 15-7, Livingston Fall 2016

CPSU-LIVINGSTON-F16S15G7

4 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 9

Todo El Tiempo: 1,307