Repara tus cosas Comunidad Tienda

Blu Studio Selfie Front Facing Camera Replacement

Introducción

Use this guide to replace the front facing camera of the Blu Studio Selfie.

Qué necesitas

  1. Blu Studio Selfie Front Facing Camera Replacement, Rear Cover: paso 1, imagen 1 de 1

    • Make sure your phone is powered off.

    • Turn the front of the phone away from you.

    • Run your fingers along the sides of the phone to identify where the case can be pulled apart.

    Editar

  2. Blu Studio Selfie Front Facing Camera Replacement: paso 2, imagen 1 de 1

    • Insert the flat end of your plastic opening into the crevice you found along the side of the phone.

    • Gently apply pressure until you feel the back case pop free of the phone.

    • Continue the previous two steps around the rest of the phone until the case is fully removed.

    Editar

  3. Blu Studio Selfie Front Facing Camera Replacement, Battery: paso 3, imagen 1 de 2 Blu Studio Selfie Front Facing Camera Replacement, Battery: paso 3, imagen 2 de 2

    • Identify the crevice at the bottom of the battery.

    • There should be enough space for you to fit your fingernail between the battery and the phone.

    • Gently lift the battery free of the phone.

    Editar

  5. Blu Studio Selfie Front Facing Camera Replacement, Midframe: paso 4, imagen 1 de 1

    • Remove all the 4mm Phillips #000 screws from the midframe.

    Editar

  6. Blu Studio Selfie Front Facing Camera Replacement: paso 5, imagen 1 de 1

    • Insert the spudger between the midframe and the display assembly.

    • Gently pry up the midframe.

    • When working with electronics, it's important to choose a tool that's ESD-safe to avoid accidental damage to the device. The metal spudger is great when you need serious prying power, but the regular black nylon spudger or a plastic opening tool should be used whenever possible.

    Editar

  7. Blu Studio Selfie Front Facing Camera Replacement: paso 6, imagen 1 de 1

    • Where the battery rested before, you will find a small clip that holds down the midframe.

    • After the rest of the midframe is detached, from the phone place the flat end of the spudger beneath the clip.

    • Gently lift up on the clip until it comes free.

    • Remove the midframe from the phone.

    Editar

  8. Blu Studio Selfie Front Facing Camera Replacement, Front Facing Camera: paso 7, imagen 1 de 3 Blu Studio Selfie Front Facing Camera Replacement, Front Facing Camera: paso 7, imagen 2 de 3 Blu Studio Selfie Front Facing Camera Replacement, Front Facing Camera: paso 7, imagen 3 de 3

    • Use tweezers to lift the black tab on the ZIF connector and pull the ribbon cable out of place.

    • Using a pair of tweezers for assistance, remove the front facing camera from its case.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Autor

con 4 otros colaboradores

Stacy Kam

Miembro Desde 01/20/16

630 Reputación

5 Guías creadas

Insignias: 14

+ 11 más insignias

Equipo

USF Tampa, Team 10-1, Remmell Spring 2016 Miembro de USF Tampa, Team 10-1, Remmell Spring 2016

USFT-REMMELL-S16S10G1

4 Miembros

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 1

Todo El Tiempo: 446